This is an old revision of the document!
This page explains the migration materials for W5200 users.
This driver is provided only for current W5200 users to help rapid migration to W5500. To get BSD version driver, please refer to the W5500 Driver page.
|Package||48 LQFP (7*7 mm^2)||48 QFN (7*7 mm^2)|
|IO Voltage / Core Voltage||3.3V / 1.2V||3.3V / 1.8V|
|Number of sockets||8 ea||8 ea|
|8bit |8bit |8bit |8bit | 8bit||8bit |8bit |1bit +7bit |8bit | 8bit|
|Control 1 byte (Block selection, Read/Write selection, SPI mode selection)||OP Code 1 bit (Read/Write Selection)|
|No Data Length field||Data Length 15bit|
|Memory Access||TX Memory and RX Memory can be accessible as general data memory.||TX Memory can be accessible as general data memory.|
|MCU Bus Interface||SPI||SPI / Indirect bus mode|
|Regulator Related Circuit||LDO output pin needs the capacitor. No need to supply the chip power (1.2V).||LDO output voltage (1.8V) must be applied to the chip power (1.8V) at the outer side of the chip package.|
|PHY Power Down Setting||PHY's power down mode can be set by configuring PHY Register.||PHY's power down mode can be set by external pin.|
|WOL Function||WOL over UDP Support||WOL over Ethernet Support|
|PHY Mode Setting||PHY mode can be set by Firmware|
|Status LED||4 LEDs (SPD / DUP / ACT / Link)||3 LEDs (SPD / DUP / Link)|
|PHY Auto MDIX Function||Not Support||Support|
|Operating Current @100Mbps Full Link||Typical 132mA||Typical 160mA|